Configuring Sntp Using Edm - Avaya 3500 series Getting Started

Boot Image tab field descriptions
The following table describes the fields on the Boot Image tab.
Name
Unit # Software Image version
Unit # Software Image in flash
Unit # Diag Image version
Unit # Diag Image in flash

Configuring SNTP using EDM

Use this procedure to configure Simple Network Time Protocol (SNTP).
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click SNTP/Clock.
3. In the work area, click the Simple Network Time Protocol tab.
4. In the PrimaryServerInetAddressType section, click a radio button.
5. In the PrimaryServerInetAddress dialog box, type a value.
6. In the SecondaryServerInetAddressType section, click a radio button.
7. In the SecondaryServerInetAddress dialog box, type a value.
8. In the State section, click a radio button.
9. In the SyncInterval dialog box, type a value.
10. In the ManualSyncRequest section, click the requestSync radio button to
11. On the toolbar, click Apply.
Getting Started
synchronize the switch with the NTP server.
Description
Indicates the loaded agent software image
for the switch.
Indicates the operational agent software
image for the switch.
Indicates the loaded diagnostic software
image for the switch.
Indicates the operational diagnostic software
image for the switch.
Configuring SNTP using EDM
March 2013 107