Configuring the switch using ACLI
Displaying current status of interfaces
Display the current operational status of interfaces and provide supplementary information
about the current port settings for Spanning Tree Protocol.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample of the show interfaces config command.
35324-PWR+(config)#show interfaces 10-14 config
Port:
10
Trunk:
Admin Status: Enable
Oper Status:
EAP Oper Status: Up
VLACP Oper Status:
STP Oper Status:
Link: Down
LinkTrap: Enabled
Link Autonegotiation:
BPDU-guard (BPDU Filtering): Disabled
BPDU-guard (BPDU Filtering): Oper Status: N/A
Port:
11
Trunk:
Admin Status: Enable
Oper Status:
EAP Oper Status: Up
VLACP Oper Status:
STP Oper Status: Discarding
Link: Down
LinkTrap: Enabled
Link Autonegotiation:
----More (q=Quit, space/return=Continue)----
Variable definitions
The following table describes the parameters for the show interfaces config
command.
<portlist.>
54
Getting Started
show interfaces [<portlist>] config
Down
Down
Discarding
Enabled
Down
Down
Enabled
Variable
Comments? infodev@avaya.com
Value
Enter the ports you want to display.
March 2013