Configuring the switch using ACLI
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample of the output of the show clock time-zone
command.
3524GT-PWR+(config)#show clock time-zone
Time zone offset from UTC is 00:00
3524GT-PWR+(config)#
Displaying the daylight savings time settings
Display the daylight savings time settings.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample of the output of the show clock summer-time
command.
3524GT-PWR+(config)#show clock summer-time
Summer time recurring is set to:
start: on Tuesday in the 1st week of June at 12:01
end: on Saturday in the 3rd week of September at 23:59
Offset: 60 minutes.
Daylight saving time is disabled
3524GT-PWR+(config)#
Setting boot parameters using ACLI
You can restart the switch and configure BootP using ACLI.
62
Getting Started
show clock time-zone
show clock summer-time
Comments? infodev@avaya.com
March 2013