Avaya 3500 series Getting Started page 101

Name
AutoPVID
NextBootMgmtProtocol
CurrentMgmtProtocol
BootMode
ImageLoadMode
CurrentImageVersion
LocalStorageImageVersion
NextBootDefaultGateway
Getting Started
Configuring system parameters using EDM
Description
When enabled, a VLAN ID can be
automatically assigned to any port.
Indicates the transport protocols to use after
the next switch restart. This is a read-only
item.
Indicates the current transport protocols that
the switch supports. This is a read-only
item.
Specifies whether to use the BootP or DHCP
server to assign an IPv4 address for the
management VLAN at the next switch
reboot. Values include:
• other: read only
• bootpDisabled: use configured server IP
address
• bootpAlways: always use the BootP
server
• bootpWhenNeeded: use the BootP
server when necessary
• bootpOrLastAddress: use the BootP
server last used
• dhcp: always use the DHCP server
• dhcpWhenNeeded: use the DHCP server
when necessary
• dhcpOrLastAddress: use the DHCP
server last used
Indicates the source from which to load the
agent image at the next boot. This is a read-
only items.
Indicates the version number of the agent
image that is currently used on the switch.
This is a read-only item.
Indicates the version number of the agent
image that is stored in flash memory on the
switch. This is a read-only item.
Indicates the IP address of the default
gateway for the agent to use after the next
time you boot the switch. This is a read-only
item.
March 2013 101