Displaying Interfaces - Avaya 3500 series Getting Started

Configuring the switch using ACLI
no

Displaying interfaces

You can view the status of all interfaces on the switch, including MultiLink Trunk membership,
link status, autonegotiation, and speed.
Displaying interfaces
Display the current configuration and status of all interfaces.
Procedure
1. Log on to ACLI in User Exec command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample of the show interfaces command with the names
variable.
3510GT(config)#show interfaces name 1 3
Port Name
---- ----
1 LabBldg
2 Testing
3 FloorBldg
The following figure shows a sample output of the show interfaces command without the
names variable.
3524GT-PWR+(config)#show interfaces
Port Trunk
---- -----
1
2
3
4
5
6
7
8
9
10
11
52 Getting Started
Variable
show interfaces [names | gbic-info] [<portlist>] [verbose]
Status
Admin Oper Link
----- ---- ----
Enable Down
Enable Up Up
Enable Down
Enable Down
Enable Down
Enable Down
Enable Down
Enable Down
Enable Down
Enable Down
Enable Down
Comments? infodev@avaya.com
Clears all lines of a previously stored custom
banner
LinkTrap Negotiation
-------- -----------
Down Enabled Enabled
Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Down Enabled Enabled
Value
Auto
Speed Duplex
----- ------
100Mbps
Flow
Control
-------
Full Symm
March 2013