Avaya 3500 series Getting Started page 100

Configuring the switch using EDM
8. Perform one of the following:
9. In the Reboot section, click a radio button.
10. In the AutoPvid section, click a radio button.
11. In the BootMode section, click a radio button.
12. On the toolbar, click Apply.
System tab field descriptions
The following table describes the fields on the System tab.
Name
sysDescr
sysUpTime
sysObjectID
sysContact
sysName
sysLocation
SerNum
AuthenticationTraps
Reboot
100 Getting Started
• To enable authentication traps, select the Authentication Traps check box.
• To disable authentication traps, clear the Authentication Traps check box.
Comments? infodev@avaya.com
Description
Provides device specific information. This is
a read-only item.
Indicates the amount of time since the
system was last booted.
Indicates the system object identification
number. This is a read-only field.
Specifies contact information for the system
administrator, which can include a contact
name or email address.
Specifies a unique name to describe this
switch.
Specifies the physical location of this
device.
Indicates the serial number of this switch.
Enables or disables authentication traps.
When enabled, SNMP traps are sent to trap
receivers for all SNMP access
authentication. When disabled, no SNMP
traps are received.
Options include:
• running: the switch remains in the running
mode (default)
• reboot : initiates a hardware reset.
March 2013