Naming Ports - Avaya 3500 series Getting Started

Naming ports

You can name ports, change the name, clear the name or reset the port name to an empty
string.
Procedure
1. Log on to ACLI in Interface Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the name [port <portlist>]
command.
port<portlist>
<LINE>
no
default
Getting Started
Variable
[no] [default] name [port <portlist>] <LINE>
Variable
Value
Important:
If you omit this parameter, the system
uses the port number you specified in the
interface command.
Value
Specifies the port numbers to be named.
Important:
If you omit this parameter, the system
uses the port number you specified in the
interface command.
Specifies the name of the port using up to 26
alphanumeric characters.
Clears the port names and resets the field to
an empty string.
Clears the port names and resets the field to
the default value (an empty string).
Naming ports
March 2013 71