Avaya 3500 series Getting Started page 39

Example
The following figure shows a sample ping response.
3510GT-PWR+#ping 120.16.125.10
Host is reachable
3510GT-PWR+#
Variable definitions
The following table describes the parameters for the ping command.
ping <A.B.C.D or Hostname>
datasize<64–4096>
{count <1–9999>} | continuous
{timeout |-t} <1–120>
interval<1–60>
debug
Getting Started
used. If no reply is received, a message indicates that the address is not
responding.
Variable Value
Specifies the IP address of the target device
in dotted-decimal notation (A.B.C.D in the
format XXX.XXX.XXX.XXX).
Specifies the size of the ICMP packet to be
sent. The data size range is from 64 to 4096
bytes.
Sets the number of ICMP packets to be sent.
The continuous mode sets the ping running
until the user interrupts it by entering Ctrl-C.
Sets the timeout using either the timeout or
-tparameter, followed by the number of
seconds the switch must wait before timing
out.
Specifies the number of seconds between
transmitted packets.
Provides additional output information such
as ICMP sequence number and trip time.
Using ping
March 2013 39