Displaying The Current Configuration - Avaya 3500 series Getting Started

Configuring the switch using ACLI
differ from the default switch configuration. If you want to view the entire configuration, you
must use the verbose qualifier to view the configuration for a specific feature.
A configuration file obtained from a stand-alone switch can only be used to configure other
stand-alone switches that have the same firmware revision and model type as the donor stand-
alone switch.
The following parameters are not saved to the configuration file:
• Configuration Image Filename
• Terminal settings (speed, width, length)
Refer to Avaya Ethernet Routing Switch 3500 Series — Fundamentals, NN47203–102, for
procedures on
• Viewing current configuration using ACLI
• Saving current configuration using ACLI
• Saving current configuration to flash memory using ACLI
• Restoring system configuration from TFTP using ACLI
• Downloading a configuration file automatically using ACLI
• Storing current ASCII configuration on a TFTP server using EDM
• Downloading an ASCII configuration from a TFTP server using EDM
• Downloading a configuration file automatically using EDM
• Storing a binary configuration file on a TFTP server using EDM
• Downloading a binary configuration file on a TFTP server using EDM
• Saving current configuration to flash memory manually using EDM

Displaying the current configuration

Display the current configuration of the switch.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
42 Getting Started
show running —config [verbose] [module <value>]
Important:
If the switch CPU is busy performing other tasks, the output of the show
running-config command can appear to intermittently stop and start. This is
Comments? infodev@avaya.com
March 2013