Avaya 3500 series Getting Started page 116

Managing Power over Ethernet (PoE) using EDM
PoE tab field descriptions
The following table describes the fields on the PoE tab.
Name
Power(watts)
OperStatus
ConsumptionPower(watts)
UsageThreshold%
NotificationControlEnable
PoweredDeviceDetectType
116 Getting Started
Description
Displays the total power (in watts) available
to the switch.
Displays the power state of the switch:
• on
• off
• faulty
Displays the power (in watts) being used by
the switch.
Lets you set a percentage of the total power
usage of the switch above which the system
sends a trap.
Important:
You must enable the traps
(NotificationControlEnable) to receive a
power usage trap.
Lets you enable or disable sending traps if
the switch power usage exceeds the
percentage set in the UsageThreshold%
field.
Lets you set the power detection type that the
switch uses to detect a request for power
from a device connected to all ports on the
switch:
• 802.3af
• 802.3af and legacy support
• 802.3at
• 802.3at and legacy support
Important:
The default setting is 802.3af. Ensure that
this setting matches the setting for the
detection type used by the powered
devices on this switch.
Comments? infodev@avaya.com
March 2013