Initiator Manage Initiator Commands - IBM TotalStorage DS300 Best Practices Manual

The align, piggyback and ping parameters set up initial values for the initiator's
attributes. By default, the align parameter is enabled, the piggyback and ping
parameters are disabled. For more information, (see initiator manage initiator
commands).
destroy initiator_list
Destroy the remote iscsi initiators in the initiator_list list. This removes all
references to these initiators from any targets or other entities which refer to
them.
info [name_list]
Output information about all specified remote iSCSI initiators
Including only one initiator in the name_list list produces the same results as
using the iscsi initiators manage initiator info command.
list
List all of the known remote iSCSI initiators.
local
Display IQN of local system's initiator.
A.16.1 initiator manage initiator commands
These commands manage remote iSCSI initiators. These commands are
available after the global initiator manage initiator command, from the global
context by preceding them by initiator initiator, or from the iSCSI initiators
context by preceding them with manage initiator.
Command
noalign
info
piggyback
ping
align enable | disable
Change whether Protocol Data Units (PDUs) should be aligned on Ethernet
frames
594
IBM TotalStorage DS300 and DS400 Best Practices Guide
Parameters Levels
enable | disable Administrator
All
enable | disable Administrator
enable | disable Administrator