Enable Initiator Access To All Totalstorage Ds400 Ports - IBM TotalStorage DS300 Best Practices Manual

Figure 9-136 Unsigned driver warning
f. After the DSM module was installed the command line window will close.
In the device manager a new device in the SCSI and raid controller
section is displayed.
Figure 9-137 Device Manager after installing DSM and MPIO
g. Reboot the server.

9.2.8 Enable initiator access to all TotalStorage DS400 ports

Microsoft Windows Server 2003 is installed and the multipath driver as well.
There are multiple paths available but no LUNs are accessible here. This step will
activate the ports of the TotalStorage DS400 for the initiators to gain access over
Chapter 9. TotalStorage DS400 installation
541