Host Bus Adapter Setup And Installation Preparation - IBM TotalStorage DS300 Best Practices Manual

DS400[A]# initiator manage WOLGA-SLOT4-(1) info
----[ Initiators ]---------------------------------------------------------
----[ Initiator 'WOLGA-SLOT4-(1)' ]----------------------------------------
---------------------------------------------------------------------------
---------------------------------------------------------------------------
DS400[A]#
Figure 9-95 Verify no port has access

9.2.4 Host bus adapter setup and installation preparation

The following steps are done to configure the IBM TotalStorage DS4000
FC2-133 host bus adapter in the IBM ^x236. The adapters are installed
in PCI slots 3 and 4.
1. Update BIOS and firmware of the HBA to the latest level supported by IBM for
the DS400. The BIOS can be downloaded from the IBM support Web page
http://www.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MI
GR-58619
See Appendix C, "How to get updates of code and documentation" on
page 623. At time of writing the supported BIOS level is 1.47. The readme file
of this update contains the details how the update need to be performed.
2. Reset the HBA to adapter Defaults.
WWN: 210000e08b0f1549
Alias: WOLGA-SLOT4-(1)
ID: 1
Port access:
Port A0
NO
LUN Mappings:
LUN
0
1
2
3
4
Port A1 Port B0
NO NO
logical [Capacity]
WOLGA-BOOT [ 30.00GB]
WOLGA-DB [ 15.00GB]
WOLGA-LOG [ 11.01GB]
WOLGA-MEDIA [100.00GB]
WOLGA-TEMP [900.00MB]
Chapter 9. TotalStorage DS400 installation
Port B1
NO
509