IBM TotalStorage DS300 Best Practices Manual page 133

Note: Press F5 to get a refreshed view. It is recommended to refresh the
view from time to time. The view is not automatically refreshed in many
conditions! For example, when the command line interface is used together
with the ServeRAID manager console, some changes might be missing
until the view is refreshed.
2. Right-click the TotalStorage DS300 enclosure in the enterprise view. Select
Configure enclosure from the content menu. Or select Actions →
Configure enclosure or click the Create logical drive button in the Logical
devices column. This allows you to manage access control list,
authentication and logical drives and arrays. This can be used later as well to
perform changes to the existing configuration.
Figure 4-57 SRM with no configured logical drives or arrays
3. The window shown in Figure 4-58 on page 116 permits all access control lists
or authentication settings to be managed. Selecting a logical drive and
choosing the Configure access control list from the context menu allows
only the modification of this access control list. The same is true for the
authentication settings. This is called Configure target information. When
the TotalStorage DS300 has no array or logical drive configuration applied,
only a new logical drive can be created. All other options will be greyed out.
For our example, verify that Create logical drive is selected as shown in
Figure 4-58 on page 116, and click Next.
Chapter 4. TotalStorage DS300 and DS400 management
115