Setting Iscsi Port Ip Addresses From Serveraid Manager - IBM TotalStorage DS300 Best Practices Manual

4.4.3 Setting iSCSI port IP addresses from ServeRAID Manager

After the management port interfaces are configured with the setup wizard, the
IBM ServeRAID manager can be used to define the network addresses of the
iSCSI interfaces. To be able to do this, a few steps must be done first.
1. Install the IBM ServeRAID Manager on a host running Microsoft Windows.
See 4.5, "IBM ServeRAID Manager installation on Microsoft Windows" on
page 91
2. Start the IBM ServeRAID Manager console. See 4.7.1, "Start IBM ServeRAID
Manager" on page 98.
3. Add a Management Station to the ServeRAID Manager console. See 4.7.2,
"Add a Management Station to a ServeRAID Manager" on page 98.
4. Add an agent to the IBM ServeRAID Manager Management Station.
Follow these steps to configure the iSCSI interfaces on both controllers:
1. Right-click controller A to open the context menu. Select from the context
menu Configure ethernet port → ETH 2 (iSCSI).
interface
manage eth2[A]
info
Figure 4-13 Configure ethernet port ETH2 controller A
2. Enter the IP address 192.168.1.61, subnet mask 255.255.255.192 and
broadcast address 192.168.1.63 into the dialog. Click OK. The settings
become immediately effective.
Chapter 4. TotalStorage DS300 and DS400 management
87