IBM TotalStorage DS300 Best Practices Manual page 290

Figure 7-71 SANsurfer — Port1 - Target settings
b. Enter the iSCSI target IP address 192.168.1.126. In this case it is the IP
address of ETH3 of controller B. The HBA is connected to ETH3 on both
controllers and the array of the logical drive COLORADO-MAIL is owned by
controller B. Then click OK.
Figure 7-72 SANsurfer — iSCSI target IP address
c. The target is added to the target list. This connection is not yet saved.
Click Configure Authentication.
272
IBM TotalStorage DS300 and DS400 Best Practices Guide