IBM TotalStorage DS300 Best Practices Manual page 289

Figure 7-70 SANsurfer — Target information
After a hardware rescan or reboot, the logical drive is seen by the operating
system.
The next steps will add a logical drive which can be accessed only with the
proper credentials.
1. Create a user and modify the access control list.
2. Add logical drive COLORADO-DB to the host. Use initiator authentication.
a. Select the port 1 of the iSCSI HBA and from the right column the Target
Settings tab. No targets are currently shown.Click the green plus sign to
add a iSCSI target.
Chapter 7. TotalStorage DS300 installation
271