Driver And Service Pack Installation And Finishing The Setup - IBM TotalStorage DS300 Best Practices Manual

Figure 9-37 Windows setup — Supported mass storage drivers

9.1.7 Driver and service pack installation and finishing the setup

Install the Broadcom network driver for the adapter. Broadcom NetXtreme
Gigabit Ethernet #2 is connected to the port number 1. This port is also shared
by the baseboard management controller (BMC). This port might be connected
into a management network. Broadcom NetXtreme Gigabit Ethernet is routed to
port number 2. This is the port close to the power supplies.
There are operating system install instructions for all IBM ^xSeries
server on the support pages. See Appendix C, "How to get updates of code and
documentation" on page 623.
1. Install the service pack1 for Microsoft Windows Server 2003. Reboot the
server.
http://www.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MI
GR-58619
2. Install remaining drivers not available during operating system installation:
a. Install the Intel chipset drivers.
b. Install ActivePCI.
c. All unknown devices are now removed.
d. Install IPMI driver. This driver is used for the BMC.
Chapter 9. TotalStorage DS400 installation
473