IBM TotalStorage DS300 Best Practices Manual page 88

To get detailed help to a specific command, enter the command followed by the
option help. The example shows help for the command interface manage.
DS300-1[A] (interface)# manage help
manage an individual interface
Usage:
manage <interface> ip <IP address> | <IP/mask>
DS300-1[A] (interface)#
Figure 4-2 Help for interface manage
It is not required to enter a command completely as long as the beginning part of
a command is unique. Pressing the tab key will complete the command after a
the first part was entered. When nothing was entered a list with available
commands or options is shown.
The U320 SCSI drives which can be installed in a TotalStorage DS300 or DS400
are not addressed by channel and SCSI ID. A unique fixed number is used
instead. The table below gives an overview of these address numbers and the
position in the enclosures. Enclosure 1 is always the TotalStorage DS300 or
DS400. Enclosure 2 and 3 are the two EXP400 which might be attached to a
TotalStorage DS400.
Different naming conventions are used to name a single drive and the position in
the enclosure. ServeRAID Manager use channel and SCSI ID. The command
line interface uses the enclosure number and the slot number beginning at 0.
Documentation specially for the EXP400 uses slot 1 to 14. The following three
tables will give an overview of the different names. It should be useful when
working extensively with the CLI or analyzing the logs.
70
IBM TotalStorage DS300 and DS400 Best Practices Guide
netmask <netmask>
broadcast <broadcast>
dhcp enable | disable
info
failback
statistics
up
down
mtu <mtu>
rename <name>
speed 10 | 100 | auto