IBM TotalStorage DS300 Best Practices Manual page 288

e. After refreshing the adapter configuration, a new target is seen under the
HBA port 1. It is the blue Send targets host. Click the Target information
tab. Then open the target list box. Only target ID 2 is shown. This is the
Send targets host target. This target is used to retrieve a list of targets
available on the TotalStorage DS300.
Figure 7-69 SANsurfer — Target information
f. After a short time SANsurfer asks for an refresh of the configuration
information. Click Yes to refresh the configuration. The new target
COLORADO-MAIL will be found.
270
IBM TotalStorage DS300 and DS400 Best Practices Guide
Note: The Send targets host target will not show an IQN or session
active. It will be always show as an unknown target or not active
session.