Totalstorage Ds400 Setup - IBM TotalStorage DS300 Best Practices Manual

access to FC0 from controller A and B. Port FC0, as described on the rear
site of the TotalStorage DS400, has the name A0 in the CLI for controller A
and B0 for controller B.
Second HBA (HBA2) is also a IBM TotalStorage DS4000 FC2-133 host bus
adapter and is installed in slot 4. IBM FAStT MSJ detects this HBA as port 1.
The world wide name has got the alias WOLGA-SLOT4-(1) assigned. This
HBA has access to FC1 from controller A and B. Port FC1, as described on
the rear site of the TotalStorage DS400, has the name A1 in the CLI for
controller A and B1 for controller B.
The logical drive used to boot from is named WOLGA-BOOT.
Each switch has a a zone for each connected HBA configured. Soft zoning was
used. Every world wide name has got an alias. The alias was used during zone
configuration. SAN switch 1 has got configured a zone Z_WOLGA_HBA1 with the
members A_WOLGA_HBA1, A_DS400_1_A_FC0 and A_DS400_1_B_FC0. SAN switch 2
has got configured a zone Z_WOLGA_HBA2 with the members A_WOLGA_HBA2,
A_DS400_1_A_FC1 and A_DS400_1_B_FC1. The zones where added to a
configuration and the configuration was activated.

9.2.3 TotalStorage DS400 setup

For this installation, five logical drive were created but only one is required to boot
from. 4.8.2, "Create arrays, logical drives, and access control on the TotalStorage
DS400" on page 131 describes how to create arrays and logical drives. The boot
logical drive was put in its own array. following RAID configuration was applied to
the TotalStorage DS400:
Table 9-1 Array and logical drive configuration of the TotalStorage DS400
Array
Array1
Array2
S-array-1
S-array-2
504
IBM TotalStorage DS300 and DS400 Best Practices Guide
Drives Owned by Raid Level
2 A 1
3 B 5
6 A 50
4 B 10
Logical Drive Size
WOLGA-BOOT 10GB
WOLGA-TEMP 900MB
WOLGA-MEDIA 100GB
WOLGA-DB 15GB
WOLGA-LOG 11GB