802.1X Port Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Trap State
Click the Apply button to accept the changes made.

802.1X Port Settings

Users can configure the 802.1X authenticator port settings.
To view this window, click Security > 802.1X > 802.1X Port Settings as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
QuietPeriod
SuppTimeout
Select to enable or disable the 802.1X trap state here.
Figure 9-10 802.1X Port Settings window
Description
Select the switch unit to configure.
Select a range of ports you wish to configure.
This allows the user to set the number of seconds that the Switch remains in the quiet
state following a failed authentication exchange with the client. The default setting is 60
seconds.
This value determines timeout conditions in the exchanges between the Authenticator
and the client. The default setting is 30 seconds. It is defined in SuppTimeout, IEEE-
802.1X-2001, page 47. The initialization value is used for the awhile timer when timing
out the Supplicant. Its default value is 30 seconds; however, if the type of challenge
involved in the current exchange demands a different value of timeout (for example, if
the challenge requires an action on the part of the user), then the timeout value is
adjusted accordingly. It can be set by management to any value in the range from 1 to
65535 seconds.
421