D-Link xStack DGS-3620 Series Reference Manual page 255

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Area ID
Neighbor ID
Hello Interval (1-65535)
Dead Interval (1-65535)
Instance ID (0-255)
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.
After clicking the Edit button, the following window will appear.
The fields that can be configured are described below:
Parameter
Hello Interval (1-65535)
Dead Interval (1-65535)
Figure 6-62 OSPFv3 Virtual Interface Settings window
Description
Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain.
The OSPFv3 router ID for the remote area.
Enter the interval time between the transmissions of OSPFv3 Hello packets, in
seconds. The Hello Interval and Dead Interval should be the same for all routers on
the same link. The default value is 10.
Enter the interval time between the receipts of Hello packets from a neighbor router
before the selected area declares that router down. The Dead Interval must be
evenly divisible by the Hello Interval.
Enter the instance ID of the interface. The default value is 0.
Figure 6-63 OSPFv3 Virtual Interface Settings - Edit window
Description
Enter the interval time between the transmissions of OSPFv3 Hello packets, in
seconds. The Hello Interval and Dead Interval should be the same for all routers on
the same link. The default value is 10.
Enter the interval time between the receipts of Hello packets from a neighbor router
before the selected area declares that router down. The Dead Interval must be
evenly divisible by the Hello Interval.
254