D-Link xStack DGS-3620 Series Reference Manual page 512

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Relay Rule
Client ID
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry based on the information entered.
Click the Delete All button to remove all the entries listed.
DHCP Relay Port Settings
This window is used to configure the state of the DHCP relay function for each port.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Port Settings as shown
below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
State
Drop – Specify to drop the packet.
Relay – Specify to relay the packet to an IP address.
MAC Address – The client's client-ID which is the hardware address of client.
String – The client's client-ID, which is specified by administrator.
Figure 10-12 DHCP Relay Port Settings window
Description
Select the unit you wish to configure.
Select the range of port, used for this configuration, here.
Select to enable or disable the DHCP relay port settings state.
511