D-Link xStack DGS-3620 Series Reference Manual page 412

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Select ACL Type
IPv6 Class
IPv6 TCP
IPv6 UDP
ICMP
IPv6 Source Mask
IPv6 Destination Mask
Click the Select button to select an ACL type.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Create button to create a profile.
After clicking the Show Details button, the following page will appear:
Figure 8-60 Egress Access Profile Detail Information window (IPv6 ACL)
Click the Show All Profiles button to navigate back to the Egress Access Profile List window.
After clicking the Add/View Rules button, the following page will appear:
Click the <<Back button to return to the previous page.
Select profile based on Ethernet (MAC Address), IPv4 address, or IPv6 address.
This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each
packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each
frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each
frame's header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of
Service (ToS) or Precedence bits field in IPv4.
Source Port Mask – Specify that the rule applies to the range of TCP source ports.
Destination Port Mask – Specify the range of the TCP destination port range.
Source Port Mask – Specify the range of the UDP source port range.
Destination Port Mask – Specify the range of the UDP destination port mask.
Select ICMP to instruct the Switch to examine the Internet Control Message
Protocol (ICMP) field in each frame's header.
The user may specify an IPv6 address mask for the source IPv6 address by
ticking the corresponding check box and entering the IPv6 address mask, e.g.
FFFF:FFFF::FFFF.
The user may specify an IPv6 address mask for the destination IPv6 address by
ticking the corresponding check box and entering the IPv6 address mask, e.g.
FFFF:FFFF::FFFF.
Figure 8-61 Egress Access Rule List window (IPv6 ACL)
411