Jwac Port Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

JWAC Port Settings

This window is used to configure JWAC port settings for the Switch.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port Settings as
shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
State
Max Authenticating
Host (0-100)
Aging Time (1-1440)
Block Time (0-300)
Idle Time (1-1440)
Figure 9-44 JWAC Port Settings window
Description
Select the switch unit to configure.
Use the drop-down menus to select a range of ports to be enabled as JWAC ports.
Use this drop-down menu to enable the configured ports as JWAC ports.
Enter the maximum number of host process authentication attempts allowed on each
port at the same time. The default value is 100.
Enter the time period during which an authenticated host will remain in the
authenticated state. Tick the Infinite check box to never age out the authenticated host
on the port. The default value is 1440.
Enter the period of time that a host will be blocked if it fails to pass authentication. The
default value is 60.
If there is no traffic during the Idle Time parameter, the host will be moved back to the
457