Dscp Map Settings - D-Link xStack DGS-3620 Series Reference Manual
Layer 3 managed stackable gigabit switch
Hide thumbs
Also See for xStack DGS-3620 Series:
- Reference manual (1371 pages) ,
- Manual (1170 pages) ,
- Product manual (502 pages)
Table of Contents
Advertisement
®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
State
DSCP Map Settings
The mapping of DSCP to queue will be used to determine the priority of the packet (which will be then used to
determine the scheduling queue) when the port is in DSCP trust state.
The DSCP-to-DSCP mapping is used in the swap of DSCP of the packet when the packet is ingresses to the port.
The remaining processing of the packet will base on the new DSCP. By default, the DSCP is mapped to the same
DSCP.
To view the following window, click QoS > DSCP > DSCP Map Settings, as show below:
Figure 6-7. DSCP Trust Settings window.
Description
Select the switch unit to configure.
Use the drop-down menu to select the port range to use for this configuration.
Use the drop-down menu to select the state. You may select Enabled or Disabled.
353
Advertisement
Table of Contents
