D-Link xStack DGS-3620 Series Reference Manual page 171

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
MLD Multicast VLAN
State
MLD Multicast VLAN
Forward Unmatched
MLD Multicast VLAN
Auto Assign VLAN
VLAN Name
VID
Remap Priority
Replace Priority
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
Click the Delete button to remove the specific entry.
Click the Profile List link to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
Figure 5-95 MLD Snooping Multicast VLAN Settings window
Description
Click the radio buttons to enable or disable the MLD multicast VLAN state.
Click the radio buttons to can enable or disable the MLD multicast VLAN Forward
Unmatched state.
Specifies to enable the auto assignment of MLD control packets to the right Multicast
VLAN. If auto assign VLAN is enabled, the Switch would check for group matching in
the profiles of all multicast VLANs to which the ingress port belongs to. If there is a
match, the result is "in profile" and the matching multicast VLAN will be set as the
packet VLAN. If this function is disabled, the Switch will do VID checking first. If the
group does not match the current profile binding to the multicast VLAN, the Switch will
drop this packet.
Enter the VLAN name used.
Enter the VID value used.
The user can select this option to enable the Remap Priority feature.
Specify the remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN. If None is specified, the packet's original priority
will be used. The default setting is None.
Tick the check box to specify that the packet's priority will be changed by the switch,
based on the remap priority. This flag will only take effect when the remap priority is
set.
170