D-Link xStack DGS-3620 Series Reference Manual page 128

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID (1-4)
Rule ID (1-128)
Action
SVID (1-4094)
Priority
Source MAC
Source Mask
Destination MAC
Destination Mask
Source IP
Source IP Mask
Destination IP
Destination IP
Mask
L4 Source Port
L4 Destination
Port
Outer VID List
802.1p
IP Protocol
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes and return to the previous page.
After clicking the Show Match button, the following page will be available:
Description
Select the profile ID to configure
Enter the rule ID to be added to the profile. If the rule ID is not specified, it will be
assigned automatically.
Select the action that will be taken here. Options to choose from are Add and Replace.
Add specifies to add a tag for the assigned S-VLAN before the Outer-VLAN tag. If there
is an S-TAG in the packet, this rule will not take effect. Replace specifies to replace the
outer-VLAN ID in the tag by the SVID. If there is no TAG in the packet, this rule will not
take effect.
Enter the S-VLAN ID to be assigned to the matched packet.
Select the 802.1p priority of the S-Tag. If the priority is not specified, the 802.1p priority
of S-Tag will be assigned by the default procedure.
Enter the source MAC address or MAC address range for the match.
Enter the source MAC address mask.
Enter the destination MAC address or MAC address range for the match.
Enter the destination MAC address mask.
Enter the source IPv4 address or IPv4 subnet for the match.
Enter the source IPv4 address mask used.
Enter the destination IPv4 address or IPv4 subnet for the match.
Enter the destination IPv4 address mask used.
Enter the Layer 4 source port ID for the match.
Enter the Layer 4 destination port ID for the match.
Enter the packet's outer-VID for the match.
Select the packet's 802.1p priority for the match.
Enter the IP protocol number used. This value must be between 0 and 255.
127