Table of Contents
Advertisement
CHAPTER 15 REMOTE CONTROLLER RECEIVER (
(12) Remote controller receive end-width select register (RMER)
This register determines the interval between the timing at which the INTREND signal is output.
RMER is set with an 8-bit memory manipulation instruction.
RESET input sets RMER to 00H.
RIN
Counter
INTREND
Caution For RMER and all the remote controller receive compare registers (RMGPHS, RMGPHL,
RMDLS, RMDLL, RMDH0S, RMDH0L, RMDH1S, and RMDH1L), disable remote controller
reception (bit 7 (RMEN) of the remote controller receive control register (RMCN) = 0) first,
and then change the value.
276
Data
Counter value = RMER
RMDLL
User's Manual U15331EJ4V1UD
µ
PD789489, 78F9489 ONLY)
Advertisement
Table of Contents
