Programming The Voice Dialer - Vd60 - Teletek electronics CA60Plus Installation Manual

8. VOICE DIALER PROGRAMMING PARAMETERS
ADDRESS 80
One can record and listen to messages in the voice dialer at this address. To record a
message place the REC jumper, select the number of the message by pressing the MSG key,
press and hold the PLAY key and dictate the message into the microphone immediately
when the LED lights up. Release the key. Remove the REC jumper when all messages have
been recorded. To listen to the messages connect an 8-16 ohm speaker to the SP socket.
Use the MSG key to select the number of the message, and press the PLAY key to listen the
recording.
DEFAULT : test message №8
ADDRESS 81
Tel No 1 A telephone number is assigned for communicating via voice dialer No. 1. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the "pulse
dialer" (ON and 0 buttons), "tone dialer" (ON and 1 buttons), "pause" (ON and 2 buttons),
"wait DIAL tone" (ON and 3 buttons) and "delete telephone number" (ON and 5 buttons)
symbols.
DEFAULT : there are no configured numbers
ADDRESS 82
Tel No 2 A telephone number is assigned for communicating via voice dialer No. 2. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the "pulse
dialer" (ON and 0 buttons), "tone dialer" (ON and 1 buttons), "pause" (ON and 2 buttons),
"wait DIAL tone" (ON and 3 buttons) and "delete telephone number" (ON and 5 buttons)
symbols.
DEFAULT : there are no configured numbers
ADDRESS 83
Tel No 3 A telephone number is assigned for communicating via voice dialer No. 3. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the "pulse
dialer" (ON and 0 buttons), "tone dialer" (ON and 1 buttons), "pause" (ON and 2 buttons),
"wait DIAL tone" (ON and 3 buttons) and "delete telephone number" (ON and 5 buttons)
symbols.
DEFAULT : there are no configured numbers
ADDRESS 84
Tel No 4 A telephone number is assigned for communicating via voice dialer No. 4. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the "pulse
dialer" (ON and 0 buttons), "tone dialer" (ON and 1 buttons), "pause" (ON and 2 buttons),
"wait DIAL tone" (ON and 3 buttons) and "delete telephone number" (ON and 5 buttons)
symbols.
DEFAULT : there are no configured numbers
ADDRESS 85
Programme the groups of message to be transmitted by the voice dialer at this
address. The possible options are 0 and 1. 0 transmits alarm messages by zones, and 1
transmits messages by events (see Supplement E).
DEFAULT : 1
CA60Plus control panel Installation manual
RECORDING AND LISTENING TO VOICE MESSAGES
ENTERING TELEPHONE NUMBER 1 FOR THE DIALER
Dialing has been assigned a default tone signal
ENTERING TELEPHONE NUMBER 2 FOR THE DIALER
Dialing has been assigned a default tone signal
ENTERING TELEPHONE NUMBER 3 FOR THE DIALER
Dialing has been assigned a default tone signal
ENTERING TELEPHONE NUMBER 4 FOR THE DIALER
Dialing has been assigned a default tone signal
GROUPS OF MESSAGES FOR VOICE DIALER
TRANSMISSION
31