Engineer Parameters - Teletek electronics CA60Plus Installation Manual

ADDRESS 50
ENGINEER CODE
DEFAULT : 7777
ADDRESS 51
NO
YES
DEFAULT : YES
ADDRESS 52
DEFAULT
SETTINGS
ADDRESS 53
DEFAULT
MANAGER
CODE
ADDRESS 54
QUICK
ARM
ENABLE
DEFAULT : YES
ADDRESS 55
ENABLE
AMBUSH
CODE
DEFAULT : YES
24

5. Engineer parameters

ENGINEER CODE CHANGE
A new access code to the alarm station engineer parameters can be assigned at
this address. The light-emitting diodes 3, 4, 5 and 6 on the keypad display light
up. These go out one by one as the new code is entered. The new code has to
be entered a second time.
BLOCKING THE HARDWARE RESET
Disables or enables the hardware RESET of the alarm station. Specialized
service is required where the hardware RESET is disabled and the en-
gineer code is obscure.
Hardware RESET is disabled.
Light-emitting diodes 1 to 6 do not light up.
Hardware RESET is enabled.
Light-emitting diodes 1 to 6 light up.
RESTORING DEFAULT PARAMETERS (SOFTWARE RESET)
Restoration of default settings of the station. The buttons 1, 2, 3, 4, 5, 6 are
pressed in succession and confirmed with the ENTER button.
RESTORING DEFAULT MANAGER CODE (PARTIAL
SOFTWARE RESET)
Restoration of the default manager code. Buttons 1, 2, 3, 4, 5, 6 are pressed in
succession and confirmed with the ENTER button.
The station restores the default 0000 manager user code.
AUTHORITY TO ARM USING A ONE PUSH-BUTTON (QUICK
ARM)
NO Arming disabled without legal user code.
Light-emitting diodes 1 to 6 do not light up.
YES Arming enabled without legal user code.
Light-emitting diodes 1 to 6 light up.
AUTHORITY CODE DURING AMBUSH (AMBUSH CODE)
NO Disabled ambush code.
Light-emitting diodes 1 to 6 do not light up.
YES Enabled ambush code. The code is made up by adding 1 to a legal user
code. There is no carrying over for codes ending in the figure 9. For example,
the ambush code for 1234 is 1235, and for 9999 it is 9990.
Light-emitting diodes 1 to 6 light up.
CA60Plus control panel Installation manual