Teletek electronics CA60Plus Installation Manual page 30

ADDRESS 75
YES
NO
DEFAULT : NO
ADDRESS 76
DEFAULT : 0
30
ANSWERING MACHINE FUNCTION
This address enables the Answering Machine function for up / down loading.
Every push of the digital button alternatively changes enabled to disabled status.
Priority should be given to any automatic answering devices (like FAX or
telephone answering machines), if such are connected to the telephone line.
The Answering Machine function should be enabled in such cases. During initial
income of a series of calls (rings), the CA60Plus temporizes the maximum
number of calls, set at Address 74. The automatic answering machine must be
adjusted to a fewer number of rings. If within four minutes there is another
series of incoming calls the CA60Plus shall answer the first one.
The display indication is shown in the table.
Enabled Answering Machine function. Light-emitting diodes 1 to 6 are lit.
Disabled Answering Machine function. Light-emitting diodes 1 to 6 are not lit.
NUMBER OF COMMUNICATION ATTEMPTS
Assign the number of attempts to connect to the central station for telephone
monitoring and the number of repetitions of voice messages at this address that
the Control Panel will make in case of unsuccessful communication or failure to
acknowledge voice messages. The value assigned at this address is the number
of attempts to be made for each of the telephones configured at addresses 60
and 63 – for the digital communicator, and at addresses 81, 82, 83 and 84 – for
the voice dialer. (Example: if the assigned value is 4 and two telephone num-
bers, the number of attempts which will be made are 8 – 4 for each telephone
number). Any messages to the central station will have priority. The attempts to
connect to the central station will be terminated after the assigned number is
reached. Transmission of the occurred events begins via the voice dialer to the
telephones at addresses 81 to 84. The panel waits for 2 sec. after each "indi-
vidual message" in order to receive a message reception acknowledgement.
This is confirmed when the user presses key 9 on the telephone. The time
needed to transmit one group of voice messages, where no confirmation has
been received, is up to 1 minute. The transmission to the other telephones be-
gins after confirmation has been received from one single telephone. After the
assigned number of voice message transmissions is reached, the attempts to
transmit voice messages will be terminated. The attempts to transmit will be
renewed to the central station first, when the next transmission event occurs.
The values between 0 and 9 are permitted. The desired value is entered by
single-pressing the key of the respective figure. Where the value of 0 is en-
tered, the panel will automatically implicate the value of 4 for the central station
and the value of 2 for the voice dialer.
CA60Plus control panel Installation manual