Start-Up Sequence; Display Overview; Power-Up Screen; Weld By Time - Dukane iQ Series User Manual

Start-up Sequence

After all connections have been completed.
1. Push the Power Switch to ON (Figure 4-2).
The generator performs a self-diagnostics sequence.
2. The Power-up screen appears briefly - Figure 4-3.
3. The next screen to appear is an Operate screen
showing information from the last weld (if there
was one). See Figure 4-3A.
Starting a Weld Cycle
1. If the generator is not powered, press its Power
Switch/Circuit Breaker to the ON position.
2. Make a choice for the setup you want to use, if
appropriate.
3. Apply the probe tip to the components to be
ultrasonically joined, and press the hand probe's
activation switch (trigger) to activate ultrasound.
4. After meeting the weld parameters (and with no
programmed Hold time) - either in Manual, Time
or Energy modes, an end of weld signal activates
when the weld is finished. An internal alarm beeps
once. (Depending on optional customer OUTPUTS
connections - System Outputs, Page 14 - external
audible or visual alerts can be activated as well.)
5. Release the probe's activation switch (trigger), and
if appropriate, apply any additional pressure while
an optional Hold time elapses. The generator signals
when that period is over with an audible alert.
Dukane Manual Part No. 403-577-00
Section 4 – Controls and Connections
Push OFF
Figure 4-2 Power Switch
DUKANE
iQ Hand Probe
Software
xxxxxxxxx
version xxxxxxx
http://www.dukcorp.com
Figure 4-3 Power-up Screen

Weld by Time

Weld Time 1.500 S
Weld Energy 24 J
# 1
Figure 4-3A Operate Screen Appears After
Power-up
Stopping a Weld Cycle
1. Release the hand probe's activation switch (trigger)
to abort a weld cycle and stop ultrasound.
2. In addition, press the generator's Power Switch/
Circuit Breaker to the OFF position to power down
the generator.
The Audible Alarm can be set ON or
OFF. See INFO, Page 27.
Push ON
Setup #1
NOTE
Current
Setup
Website
Address
Page