Table of Contents
Advertisement
120 BES50 administration
The reset button is located inside the switch housing approximately 2.54 cm (1
inch) from the faceplate. Use a nonmetallic object to press the reset button at the
location indicated on the front panel. See
(page 127)
Cannot display left menu panel of the Web-based user interface
If the Web-based user interface does not display the left menu panel, Java
Runtime Environment (JRE) may not be installed on the management PC,
or Java scripts and Java applets may be disabled. Perform the following
checks.
Procedure steps
Step
1
2
3
4
Determining the BES50 IP address allocated by the DHCP server
By default, the BES50 tries to obtain IP configuration from a Dynamic Host
Configuration Protocol (DHCP) server. If the DHCP server is not reachable
when BES50 is initializing (for instance, if the DHCP server is offline, or if a
network problem is preventing BES50 from communicating with the DHCP
server), the BES50 uses the default IP address 192.168.1.128 until it can
successfully obtain IP configuration from a DHCP server. At this point, you
can lose Web-based user interface communication to the BES50 that was
using the default address.
Copyright © 2006, Nortel Networks
.
or
"BES50FE/GE-24T PWR front panel" (page
Action
Exit from all existing Web browser sessions.
Check that Java Runtime Environment (JRE) version 1.5.0_07-b03
or later is installed on your computer. If not, download the latest
version from www.java.com.
Check that Java scripting and Java applets are enabled on each
of the following:
•
Web browser
•
firewall
•
software that controls Java behavior
Refer to the respective documentation for details about enabling
Java scripting and Java applets.
Launch the Web-based user interface to the BES50 switch.
SMB
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
ATTENTION
"BES50FE/GE-12T PWR front panel"
—End—
127).
Nortel Networks Confidential
Hide quick links:
Advertisement
Table of Contents
