Function
Traffic prioritization
IP settings
System log
SNTP
Twisted-pair cable and pin assignments
For 10/100BASE-TX connections, the twisted-pair cable must have two pairs
of wires. For 1000BASE-T connections, the twisted-pair cable must have
four pairs of wires. Each wire pair is identified by two different colors. For
example, one wire might be red and the other might be red with white stripes.
Also, an RJ-45 connector must be attached to both ends of the cable.
Copyright © 2006, Nortel Networks
.
Parameter
Ingress Port Priority
Weighted Round Robin
IP DSCP Priority
Management VLAN
IP Address
Subnet Mask
Default Gateway
DHCP
BOOTP
Status
Messages Logged
Messages Logged to Flash
Clock Synchronization
CAUTION
Do not plug a phone jack connector into any RJ-45 port. Use only
twisted-pair cables with RJ-45 connectors that conform with FCC
standards.
CAUTION
Each wire pair must be attached to the RJ-45 connectors in a
specific orientation.
SMB
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
Twisted-pair cable and pin assignments 157
Default
0
For the BES50FE,
Queue: 0, 1, 2, 3
Weight: 1, 2, 4, 8
For the BES50GE,
Queue: 0, 1, 2, 3, 4, 5, 6, 7
Weight: 1, 2, 4, 6, 8, 10, 12, 14
Disabled
1
DHCP assigned, otherwise
192.168.1.128
255.255.255.0
0.0.0.0
Enabled
Disabled
Enabled
Levels 0-7 (all)
Levels 0-7
Disabled
Nortel Networks Confidential