Setting Ip Parameters Using The Web-Based Management Interface - Nortel 5500 series Installation Manual

48 Installing the Nortel Ethernet Routing Switch

Setting IP parameters using the Web-based Management Interface

To set IP parameters using the Web-based Management Interface, perform
the following tasks:
Step
1
2
3
4
5
Copyright © 2005 - 2006, Nortel Networks
.
Note: IP parameters are changed during this procedure. Changes to
IP parameters can result in the loss of web browser connectivity to the
switch.
Action
Using the procedure
(page 49), assign a default IP address to the switch.
Connect a computer to the switch through a data port using a
standard RJ-45 network cable.
Open a web browser on the attached computer and enter the factory
default IP address of the switch in the following format: http://<IP
Address>.
The main screen of the Web-based Management Interface will open.
Select Configuration > IP from the menu. This screen is illustrated
below.
IP configuration screen
Using the fields provided, configure the IP parameters. All fields
are divided into three columns: Configurable, In Use, and Last
BootP. The Configurable column is used to configure a new value
for the field. The In Use column represents the current value used
by the switch and the Last BootP column is used to display a value
Nortel Ethernet Routing Switch 5500 Series
NN47200-300 2.00 Standard
5.0 7 July 2006
"Setting IP parameters using the UI button"
Installation
Nortel Networks Confidential