Using The Web-Based User Interface - Nortel BES50GE-12T PWR User Manual

Using the Web-based user interface

Use the information in this chapter to understand how to use the Web-based
user interface to view and configure information about the Business Ethernet
Switch (BES) 50 Series switch.
Prerequisites
•
•
The Web pages of the Web-based user interface can load at different speeds
depending on which Web browser you use.
Web browser capabilities, such as page bookmarking, refresh, and page forward
and page back, function as they would in any other Web site. However, these
capabilities do not enhance the functionality of the Web-based user interface.
Nortel recommends that you use only the navigation tools provided in the
management interface.
Copyright © 2006, Nortel Networks
.
To use the Web-based user interface, you need the following items:
— a computer connected to a network port that is a member of the
management Virtual Local Area Network (VLAN)
— Microsoft Internet Explorer 5.5 or later installed on the administration
computer
Prior to accessing the switch from a Web browser, perform the following
tasks:
— "Setting up the Web-based user interface" (page
— If required, configure the switch with a valid IP address, subnet mask,
and default gateway. (Default: 192.168.1.128/255.255.255.0/0.0.0.0)
See "Initial configuration" (page
— Set a new password by using the Web-based user interface.
Web-based user interface access is password controlled. (Default
user name: nnadmin; default password : PlsChgMe!) See
the administrator password" (page
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
22).
23).
ATTENTION
ATTENTION
SMB
17
18).
"Changing
Nortel Networks Confidential