Adding Static Members To Vlans (Vlan Index) - Nortel BES50GE-12T PWR User Manual

Variable definitions
Variable
Current
New
VLAN ID
VLAN Name
Status

Adding static members to VLANs (VLAN index)

Use this procedure to configure port members for the selected VLAN index.
Assign ports as tagged if they are connected to 802.1Q VLAN compliant
devices, or untagged if they are not connected to any VLAN-aware devices.
Or, configure a port as forbidden to prevent the switch from automatically
adding it to a VLAN through the GVRP.
You can also use the VLAN Static Membership by Port page to configure
VLAN groups based on the port index. However, this configuration page
can add ports to VLANs only as tagged members.
The default untagged VLAN (VLAN 1) contains all ports on the switch and can
only be modified by first reassigning the default port VLAN ID.
Procedure steps
Step
1
2
3
4
5
Copyright © 2006, Nortel Networks
.
Value
Lists all the current VLAN groups created for this system. You can
define up to 32 VLAN groups. (Default untagged VLAN: VLAN 1.)
Use this area to specify the name and numeric identifier for new
VLAN groups. The VLAN name is only used for management on
this system; it is not added to the VLAN tag.
Type the numeric identifier of the configured VLAN. (Range: 1 to
4094, no leading zeroes.)
Type the VLAN name. (Range: 1 to 32 characters.)
Select to enable the specified VLAN. If the VLAN is not enabled, it
is suspended and therefore does not pass packets.
Action
From the main menu, choose Application > VLAN > 802.1Q VLAN
> Static Table.
Select a VLAN from the list.
Modify the VLAN name and status if required.
Select the membership type for each port and trunk (Tagged,
Untagged, Forbidden, None).
Click Submit.
SMB
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
Configuring IEEE 802.1Q VLANs 71
ATTENTION
—End—
Nortel Networks Confidential