Figure 2 Dynamic Protocol-Based Vlan; Table 2 Pids Not Available For User-Defined Protocol-Based Vlans - Nortel 8300 User Manual

Figure 2
Dynamic protocol-based VLAN
User-defined protocol-based VLANs
You can create user-defined protocol-based VLANs in support of networks
with non-standard protocols. For user-defined protocol-based VLANs, you
can specify the Protocol Identifier (PID) for the VLAN. For release 2.1, you
can enter the PID as a range of hexadecimal identifiers separated by a
comma (,) a dash (-), or some combination of the two. Note that you can
provide a maximum of 8 PIDs in this range.
Frames that match the specified PID for the following are assigned to that
user-defined VLAN:
•
•
•
Table 2 "PIDs not available for user-defined protocol-based VLANs" (page
21)
be designated as user-defined PIDs.
Table 2
PIDs not available for user-defined protocol-based VLANs
PID (hex)
04xx, xx04
F0xx, xxF0
0000-05DC
0600, 0807
0BAD
4242
Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device Manager
Copyright © 2005-2007, Nortel Networks
.
the ethertype for Ethernet type 2 frames
the PID in Ethernet SNAP frames
the DSAP or SSAP value in Ethernet 802.2 frames
lists the predefined policy-based PIDs, which are reserved and cannot
Nortel Ethernet Routing Switch 8300
NN46200-510 03.01 Standard
4.0 27 August 2007
Description
sna802dot2
netBIOS
Overlaps with 802.3 frame length
xns
VINES
IEEE 802.1D BPDUs
VLANs 21