Nortel BES50GE-12T PWR User Manual page 91

6
7
8
Variable definitions for the ACL configuration page
Variable
Name
Type
Variable definitions for the Standard IP ACL configuration page
Variable
Action
Address Type
Copyright © 2006, Nortel Networks
.
i. If you select Host, type an IP address.
ii. If you select IP, type an IP address and a subnet mask
address.
To configure an Extended ACL:
a. Select the action.
b. Select the source address type.
i. If you select Host, type an IP address.
ii. If you select IP, type an IP address and a subnet mask
address.
c. Repeat the previous step for the Destination Address Type.
d. Set any other required criteria, such as protocol type, source
port, source port bit mask, destination port, or destination port
bit mask.
Click Submit.
Click Back to return to the ACL Configuration page to set up
additional ACLs.
Value
Type the name of the ACL. (Maximum length: 15 characters)
Select the ACL filter type.
• Standard filters packets based on the source IP address.
• Extended filters packets based on the source or destination IP
address, as well as the protocol type and protocol port number.
Value
Select the permit or deny rules.
Select the source IP address. (Default: Any)
• Any includes all possible addresses.
• Host specifies a specific host address.
• IP specifies a range of addresses.
SMB
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
Configuring Access Control Lists
—End—
91
Nortel Networks Confidential