56 BES50 advanced features configuration
3
Variable definitions
Variable
Name
Admin
Speed/Duplex
Flow Control
Autonegotiation (Port
Capabilities)
Trunk
Creating trunk groups
Use these procedures to configure static and dynamic Link Aggregation
Control Protocol (LACP) trunks. You can create up to six trunks at a time.
Navigation
•
•
•
Copyright © 2006, Nortel Networks
.
Click Submit.
Value
Type a label for the interface. (Range: 1 to 64 characters)
Clear the check box to manually disable an interface.
You can disable an interface due to abnormal behavior, such as
excessive collisions, and then reenable it after the problem is
resolved. You can also disable an interface for security reasons.
If autonegotiation is disabled (cleared), select port speed and
duplex mode manually.
If autonegotiation is disabled (cleared), clear to configure flow
control manually.
Select to enable autonegotiation and to specify the capabilities to
be advertised as follows:
•
10half—Supports 10 Mb/s half-duplex operation
•
10full—Supports 10 Mb/s full-duplex operation
•
100half—Supports 100 Mb/s half-duplex operation
•
100full—Supports 100 Mb/s full-duplex operation
•
1000full—Supports 1000 Mb/s full-duplex operation
Clear to disable autonegotiation and to configure speed duplex
and flow control manually. (Default: Autonegotiation enabled;
Advertised capabilities for 100BASE-TX—10half, 10full, 100half,
100full; 1000BASE-T—10half, 10full, 100half, 100full, 1000full)
Indicates if a port is a member of a trunk.
"Configuring a static trunk" (page 57)
"Enabling LACP on selected ports" (page 58)
"Configuring LACP parameters" (page 59)
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
—End—
SMB
Nortel Networks Confidential