Table of Contents
Advertisement
Variable
Mode
Trunk Member
Link Layer Discovery Protocol (LLDP) configuration
Use these procedures to configure devices to share information.
Navigation
•
•
Configuring the LLDP
Use the LLDP Configuration page to configure the LLDP for the switch.
Procedure steps
Step
1
2
3
Variable definitions
Variable
LLDP
Copyright © 2006, Nortel Networks
.
Value
Select a VLAN membership mode for an interface:
•
1Q Trunk—Specifies a port as an endpoint for a VLAN
trunk. A trunk is a direct link between two switches, so the
port transmits tagged frames that identify the source VLAN.
Frames belonging to the default port VLAN (associated with
the PVID) are also transmitted as tagged frames.
•
Hybrid—Specifies a hybrid VLAN interface. The port can
transmit tagged or untagged frames.
(Default: Hybrid)
Indicates if a port is a member of a trunk. To add a trunk to the
selected VLAN, use the last table on the VLAN Static Table page.
"Configuring the LLDP" (page 75)
"Configuring the LLDP interfaces" (page 76)
Action
From the main menu, choose Application > LLDP > Configuration.
Select the Enabled check box and type the required setting values.
Click Submit.
Value
Select to enable LLDP. This setting allows each port to receive
and transmit Type Length Values (TLVs).
Using the Nortel Business Ethernet Switch 50 Series
NN47924-301 01.01 Standard
1.00 October 2006
Link Layer Discovery Protocol (LLDP) configuration 75
—End—
SMB
Nortel Networks Confidential
Hide quick links:
Advertisement
Table of Contents
