Wheel Hub; Tire Pressure - Kubota ME8200DTN Workshop Manual Supplement

ME8200DTN, WSM

[3] WHEEL HUB

[4] TIRE PRESSURE

Screw circle diameter (A)
Number of screws
Screws
Hub pilot diameter (B)
Through the tire pressure is factory-set to the prescribed level,
it naturally drops slowly in the course of time. Thus, check it every
day and inflate as necessary.
To inflate the wheel tires, use an air compressor or hand pump.
B Recommended Inflation Pressure
Maintain the pressure shown below for normal use.
Combination Tire sizes
Front 280 / 70 R18
1
Rear 380 / 70 R28
Front 280 / 70 R18
2
Rear 360 / 70 R28
Front 250 / 80 - 18
3
Rear 380 / 70 R28
Front 250 / 8 - 16
4
Rear 380 / 70 R24
Maintain the maximum pressure in front tires, if using a
front loader of when equipped with lots of front weight.
(A) Insufficient
(B) Standard
NG-16
Front wheel hub Rear wheel hub
152.4 mm (6 in.) 203.2 mm (8 in.)
6
M14 x P1.5 M16 x P1.5
117.4 mm (4.62 in.) 152.4 mm (6 in.)
Inflation pressure
160 kPa (1.6 )
120 kPa (1.2 )
160 kPa (1.6 )
140 kPa (1.4 )
250 kPa (2.5 )
120 kPa (1.2 )
250 kPa (2.5 )
120 kPa (1.2 )
(C) Excessive
(D) Ground
KiSC issued 04, 2006 A
GENERAL
8
0000003613E
0000003614E