Disassembling And Assembling; 2Wd Type Front Axle - Kubota L4400 Workshop Manual

L4400 , WSM

[3] DISASSEMBLING AND ASSEMBLING

(1) 2WD Type Front Axle

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Front Wheel Hub
1. Remove the front wheels.
2. Remove the cotter pin and remove the slotted nut (2).
3. Disconnect the knuckle arm (1) and tie-rod end (3).
4. Remove the front wheel cap (4).
5. Draw out the cotter pin.
6. Remove the slotted nut (5).
7. Remove the collar.
8. Remove the front wheel hub (6) with a puller.
(When reassembling)
• Replace cotter pin with a new one.
• Apply grease to the oil seal (8) in the front wheel hub.
IMPORTANT
• After tightening the slotted nut to the specified torque, insert
a cotter pin and bend it as shown in the figure.
• Pack in the grease to the bearing in the front wheel hub.
Tightening torque
(1) Knuckle Arm
(2) Tie-rod End Slotted Nut
(3) Front Wheel Hub
(4) Front Wheel Cap
(5) Front Wheel Hub Slotted Nut
6-S11
137 N·m
Front wheel mounting nut 14.0 kgf·m
100 ft-lbs
29.4 to 39.2 N·m
Front wheel hub slotted nut 3.0 to 4.0 kgf·m
21.7 to 28.9 ft-lbs
39.2 to 49.0 N·m
Tie-rod end slotted nut 4.0 to 5.0 kgf·m
28.9 to 36.2 ft-lbs
(6) Front Wheel Hub
(7) Knuckle Shaft
(8) Oil Seal
(9) Taper Roller Bearing
(10) Taper Roller Bearing
FRONT AXLE
W1022004
KiSC issued 07, 2007 A