Mitsubishi 3000GT 1991 Service Manual page 1008

prevent
retractor
rotation
INTERIOR -
INSPECTION
BUCKLE SWITCH
(1) Disconnect the buckle switch connector.
(2) Check the continuity between the terminals.
Terminal
Buckle unlock
Buckle lock
NOTE
O-O indicates that there is continuity between the terminals.
BUZZER
Check that buzzer sounds when battery voltage is applied to
the buzzer terminal.
SERVICE POINTS OF INSTALLATION
6. INSTALLATION OF OUTER SEAT BELT
Bead
(1) Positively insert the paw1 to prevent the retractor from
(2) Install the anchor plate along the bead of the body.
4. INSTALLATION OF INNER SEAT BELT
(1) Route the seat belt switch connector harness on the
(2) Use clips to secure the harness to the adjuster bracket.
(3) Fit the locking claw of the inner seat belt positively in
2. INSTALLATION OF OUTER SEAT BELT
(1) Positively insert the paw1 to prevent the retractor from
(2) After connecting the seat belt harness with the body
rotation
TSB
Revision
Seat Belt
1
0
rotating in the hole provided on the body.
adjuster bracket.
the locking hole provided in the seat bracket.
rotating in the hole provided on the body.
harness, insert the clip on the connector into the hole
on the body panel.
2 3 4
0 0
0