Twinax Setup Menu - IBM InfoPrint 20 User Manual

Coax Setup Menu
Item
960
BUFFERSIZE
1920*
2560
3440
3564
ON*
EARLY COMPL
|
OFF
|
|
|
|
|
|
|
|

Twinax Setup Menu

Use the Twinax Setup Menu to configure the twinax attachment. The
following table describes the settings you can change from the Twinax Setup
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The Twinax Setup Menu appears only if you have the twinax network
interface card installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
Important! If you change SCS ADDR or IPDS ADDR, you must power off
the printer, wait ten seconds, and then power on the printer for the new
value to take effect.
2. For more information about configuring the twinax attachment, see IBM
Network Printers: Twinax/Coax Configuration Guide.
3. If you are unfamiliar with using the operator panel to work with menus,
please read "Using the Operator Panel Keys" on page 23 and "Navigating
Menus" on page 24 before continuing.
124
InfoPrint 20: User's Guide -- CD Version
Value
Specifies the buffer size in bytes.
Turns early print completion on or off for non-IPDS data
sent over the coax attachment. To turn early print
completion on or off for IPDS data over the twinax network
attachment, use the EARLY COMPL item on the IPDS
Menu.
v ON—sends an "order complete" as soon as data is
received.
v OFF—waits until the print job is physically complete to
send "order complete."
Description