Unpacking And Setting Up The Printer - IBM InfoPrint 20 User Manual

__ 9. Install other options, such as paper trays, the duplex unit, extra
__ 10. Install print drivers and configure your host environment. See
__ 11. Get familiar with your printer. See "Chapter 3. Using the Operator

Unpacking and Setting Up the Printer

Before you install your printer, make sure you have a place large enough to
put it. Without any of its optional features attached, the printer dimensions
are:
v Width: 22.8 inches (580 mm)
v Depth: 23.7 inches (602 mm)
v Height: 16.3 inches (413 mm)
In addition, make sure you leave enough room around the printer to access
and operate it, and make sure there is enough room around all power plugs
for you to easily disconnect the power cord. IBM recommends leaving at least
13.6 inches (340 mm) in the back of the printer, 30.4 inches (760 mm) in the
front of the printer, 8 inches (200 mm) on each side, and 16 inches (400 mm)
above the printer.
Remove all items from the packing box including packaging pieces. Lift the
printer and place it on a flat surface. If any of the following items are missing,
contact your point of purchase:
v IBM InfoPrint 20
v 500-sheet paper tray
v Toner cartridge
v The following documents: IBM InfoPrint 20: Quick Reference Card, IBM
InfoPrint 20: Quick Setup Poster, and IBM InfoPrint 20: Safety and Warranty
Information
10
InfoPrint 20: User's Guide -- CD Version
memory, the IPDS SIMM, flash memory, the hard drive, and network
interface cards (Ethernet, token-ring, twinax, and coax). See
"Chapter 8. Installing Printer Options" on page 147.
"Installing Printer Drivers" on page 18.
Panel" on page 21.