Table of Contents
Advertisement
a. Lay the token-ring card in front of you with the faceplate toward you.
b. On the right, rear side are six pins and two small jumpers.
v If you are installing the card for a 4 Mbps network, place a jumper
over the pins labeled 4.
v If you are installing the card for a 16 Mbps network, place a jumper
over the pins labeled 16.
3. When the printer is not printing, switch the printer power off.
Attention: Do not switch the power off if the printer is printing a page.
This action jams the printer.
4. Unplug the printer from the wall outlet.
5. Remove the power cord from the back of the printer.
6. Move to the back of the printer. Two slots for interface cards are located at
the right side of the back of the printer. If you are installing only one card,
use the top slot.
Chapter 8. Installing Printer Options
155
Advertisement
Table of Contents
