Table of Contents
Advertisement
|
|
|
|
29 OUTPUT FULL
30 MEMORY OVERFLOW
31 MEMORY ALLOC ERROR
32 PRINT OVERRUN
40 MEMORY OPTION ERROR
in the tray and the end guides in the tray are properly set. For the
auxiliary tray, verify the AUXSIZE setting on the Paper Menu (see
"Defining the Auxiliary Tray Paper Size" on page 64). You may also
need to open and close the top cover to clear the condition.
Meaning: The output bin is full.
Action: Remove the output from the bin.
Meaning: Memory overflow. The printer has received more data than
it can fit into its memory. This can happen when the printer receives
too many soft fonts, macros, or complex graphics.
Action: If the AUTOCONTINU item in the Config Menu is set to ON,
printing resumes in ten seconds. Otherwise, press the Continue key.
Check the current page for errors. See "Memory Requirements" on
page 5 for information on how much memory various options
require.
Meaning: The printer cannot allocate the memory required to print a
job.
Action: If the AUTOCONTINU item in the Config Menu is set to ON,
printing resumes in ten seconds. Otherwise, press the Continue key.
Check the current page for errors.
Meaning: A page is too complex to print at the current resolution.
Action: Do one of the following:
v If QUALITY is set to 1200, change it to something else and resubmit
the job. Use your printer driver or the Config Menu. The driver
setting overrides the menu setting. See "Configuration (Config)
Menu" on page 95.
v If you are feeding paper long-edge first, change it to short-edge
first.
v Add more memory. See "Memory Requirements" on page 5 for
information on how much memory various options require.
Meaning: A SIMM module is not properly seated in its slot or is in
some other way defective.
Action: Turn off the printer. Pull out the controller card. Reseat the
SIMM module. If the message recurs after you restart the printer, call
for service.
Appendix C. Printer Messages
217
Advertisement
Table of Contents
